Maintenance - Concept beetle VP 508 series Bedienungsanleitung

EN
1. Adjust the power controller to the minimum setting.
2. Insert the plug into the mains outlet.
3. Press the main switch on the vacuum cleaner.
4. Set the required suction power using the controller.
5. After vacuuming, turn off the product and unplug from the mains outlet.
6. To wind the power cord, press the holder in the back position to make it push against the winder button. Use your
other hand to make sure the power cord does not whip around.
CHECKING THE CONTAINER CONTENT LEVEL
If the suction power is lower, or the dust content level indicator is red even though the nozzle is lifted above the floor,
empty the container immediately.
NOTE: If the dust level indicator remains red after replacing the container, check for the following:
- One of the air passages is obstructed (hoses, telescopic tube, suction inlet, floor nozzle, or other adapters);
- The air inlet filter in the dust bin is fouled or old. Then it must be cleaned or replaced.
- The air outlet filter is fouled or old. Then it must be cleaned or replaced.
Check for each of the above possible causes and eliminate the problem before you resume vacuuming. If the cause of
the problem cannot be identified, take the product to the nearest service center. Never use the vacuum cleaner if the
container level indicator is completely red. The motor could be damaged irreparably.

MAINTENANCE

As a preventative measure, we recommend emptying the container and cleaning the
filters of the vacuum cleaner after each use.
EMPTYING THE CONTAINER
EMPTYING THE CONTAINER
1. Unplug the vacuum cleaner from the mains. Disconnect the hose from the suction
1. Unplug the vacuum cleaner from the mains. Disconnect the hose from the suction
inlet.
inlet.
2. Push the latches on the container holder, and shift the container upwards (Fig. 3).
2. Push the latches on the container holder, and shift the container upwards (Fig. 3).
3. Press the latch on the bottom of the front side of the container, open the latch and
3. Press the latch on the bottom of the front side of the container, open the latch and
empty the contents of the container (see Fig. 4).
empty the contents of the container (see Fig. 4).
4. Close the container and return it to the vacuum cleaner. Make sure the container is
4. Turn-release and remove the filter cone. Clean the space above it. Follow the steps
positioned properly. You should hear a clicking sound from the handle latches.
in reverse to put it back, turn-lock.
5. Close the container and return it to the vacuum cleaner. Make sure the container is
positioned properly. You should hear a clicking sound from the handle latches.
REPLACING FILTERS
The filters should be replaced at least twice a year or whenever obviously fouled or
worn. The filters should be checked after each use of the vacuum cleaner.
Never use the vacuum cleaner without properly installed filters to avoid damage to
the vacuum cleaner.
Unplug the vacuum cleaner from the mains outlet before replacing the filters.
Suitable filter types are available from your local retailer, or they can be ordered from
the manufacturer.
40
36
EN
(Obr. 3)
(Fig. 3)
(Fig. 4)
(Obr. 4)
VP5060
VP 508x