Bartscher 600 series Bedienungsanleitung Seite 32

- Choose the desired temperature thanks to the thermostat (1); the two lamps light on. The green
light (2) stays on all the time to indicate that there is tension, while the orange one (3) lights off as
soon as the oven reaches the right temperature.
In order to switch off the electric oven, turn the control knob into the 0 position.
Abnormal functioning
If for any reason, the appliance does not start or stops working during use, first check the energy
supply and that the control knobs are set correctly, and then call customer service.
Some problems and possible solutions
Problem
No heat
No indicator light
Slow and/or insufficient heat
If the ceramic glass is cracked or broken, stop any work that has begun, disconnect the
appliance from the electrical supply and place it in an appropriate place until it can be
repaired by qualified personnel.
CARE AND MAINTENANCE OF THE APPLIANCE
Cleaning
ATTENTION! Before any cleaning, make sure the appliance is disconnected from the electric
mains. When cleaning, avoid using direct or high pressure water sprays on the appliance.
Cleaning should be done when the appliance is cold.
Steel parts can be cleaned with warm water and neutral detergent, using a cloth. The detergent
should be suitable for cleaning stainless steel and should not contain abrasive or corrosive
substances. Do not use ordinary steel wool or anything similar, as this can deposit rust-forming iron
particles, and avoid contact of iron objects with the stainless steel. It is also unadvisable to use
sandpaper or emery paper. Pumice powder should only be used for heavily encrusted dirt; however,
a synthetic abrasive sponge or stainless steel wool used in the direction of the glazed finish would
be preferable. After washing, dry the appliance with a soft cloth.
When cleaning, abrasive powders of any type, chlorine-based detergents and bleach should all be
avoided. Also avoid pouring cold liquids on appliances while they are hot, or cracks could form
which could cause the appliance to become deformed or broken.
- Check the power supply
-
Check the condition of the hotplate and/or the
heating element
-
Check the switch/thermostat
- Check the power supply
-
Check the light bulb
- Check the setting of the energy regulator and/or
switch and/or thermostat
-
Check the condition of the heating elements and/or
hotplates
- Check the quantity of food to be cooked
Pag. 31/45
Possible solution