Bartscher 600 series Bedienungsanleitung Seite 31

ATTENTION! All the parts, protected and sealed by manufacturer may not be regulated by
the installer if not specifically indicated.
Electric round hotplates (fig. 8 – p. 4)
In order to switch on the hotplates on the electric cookers, proceed in the following way:
- Turn the knob (1) to the desired position; the green lamp lights on to show that the hotplate is
turned on.
When turning on the hotplate, it is advisable to set it to the maximum temperature for a few minutes
so it will quickly reach the desired temperature; the control knob can then be adjusted to the desired
setting.
In order to switch off the hotplate, turn the knob to the 0 position.
ATTENTION! Never leave the appliance unattended while in use. Never leave the hotplate
switched on without cookware or with empty cookware. Always use cookware with an
adequate diameter for the hotplate, preferably not smaller and with a flat bottom.
Glass ceramic electric cooker (fig. 9, 10 – p. 4)
The hotplates are turned on as follows:
- Turn the control knob (1) to the desired position; the indicator light (2) comes on to indicate
that the selected hotplate is on (the selected area will become red on the glass ceramic surface).
The control knob (fig. 10 – p. 4) is connected to the power regulator, so when it is turned the
machine is switched on. Depending on the setting, the hotplate turns on and off in a cycle in
order to maintain a constant temperature. The higher the setting selected on the control knob,
the more time it remains on rather than off. When turned to the highest setting, the hotplate
stays on constantly at the maximum supplied power.
-
In order to avoid dangerous and uncontrolled temperature increases, the machine is fitted with
an automatically resetting safety thermostat that intervenes at a set temperature.
ATTENTION! Never leave the appliance unattended while in use. Never leave the glass
ceramic cooker switched on without cookware or with empty cookware. If the ceramic glass is
cracked or broken, stop any work that has begun, disconnect the appliance from the electrical
supply and place it in an appropriate place until it can be repaired by qualified personnel.
Electric oven (fig. 11 – p. 5)
In order to switch on the electric oven, choose the desired cooking temperature and proceed in the
following way:
INSTRUCTIONS FOR USE
Position [N°]
0 Hotplate off
1 Maintaining temperature
2 Cooking small quantities
3 Cooking large quantities
4 Cooking at medium temperature
5 Cooking at high temperature
6 Starting cooking
Pag. 30/45
Use