Installation; Start-Up; Adjusting The Motion Detector - LIVARNOLUX IAN 298451 Montage-, Bedienungs- Und Sicherheitshinweise

Installation

Make sure you will not be drilling into electrical,
gas or water lines inside the wall. Use a power
drill to drill the holes into the brick wall. Always
observe all safety instructions for the power drill
in the ma nual for the power drill. Death or injury
due to electric shock may otherwise result.
When selecting the mounting location, pay atten-
tion to the following:
Make sure that the spotlight
desired area. You can move the spotlight
vertically.
Make sure the motion detector
desired area. The motion detector
maximum coverage range of max. 10 m, with
a coverage angle of about 180° (depending
on the mounting height – a height of
1.80–2.50 m is ideal) (Fig. D, E, F).
Make sure the motion detector
minated at night by street lighting. This can
influence its functioning.
Use the mounting bracket
mark the drilling holes onto the wall. Ensure
that there are no cables or wires in this area
in the wall. Drill two holes (Ø 8 mm) and in-
sert the wall plugs
bracket with the help of the screws
2
and check the tight fit.
Open the connection box
crosshead screw driver to loosen the fixing
screws of the connection box
17
The cable gland has to be loosened, then run
the flexible supply line, e. g. type H05RN-F
3G 1.0 mm , through the cable gland
2
and into the connection box
illuminates the
8
covers the
10
has a
10
is not illu-
10
as a pattern to
2
. Screw the mounting
3
1
by using a
13
(Fig. B).
13
16
. Open the
13
terminal block
driver to loosen the screws.
Attach ferrules to the wires of the supply line.
Also attach the cord anchorage
supply line and use pliers to tighten it on the
supply line (Fig. B). Connect them with the
terminal block
Pay attention to the markings on the terminal
block (L for live, N for neutral and
12
the earth wire) (Fig. B). Close the terminal
block again by fastening the screws.
12
Important: if the external flexible cable or
8
cord of this luminaire is damaged, it shall be
exclusively replaced by the manufacturer or
his service agent or a similar qualified person
in order to avoid a hazard.
Close the connection box
ing the fixing screws
Now attach the spotlight
bracket
2
, spring washers
7
tooth lock washers
Re-install the fuse for this circuit or switch on
at the circuit breaker (I position) in the fuse
box.

Start-up

Adjusting the motion detector

Depending on the pre-adjustments of the motion
detector , the product will switch itself on for a
10
certain period of time as soon as the motion de-
tector detects movement. These
10
by using a slot head screw
12
14
in the connection box
12
again by fasten-
13
.
17
to the mounting
8
using the included locking screws
, flat washers
6
(Fig. A).
4
GB/IE/NI
to the
.
13
for
and
5
9