The Correct Installation Location; Required Tools; Prior To Installation - LIVARNOLUX LLES B2 Bedienungsanleitung Und Serviceinformationen

The correct installation location

Select the installation location carefully and prepare well for the installation.
 Place all individual parts, required tools and installation material so they are well arranged and ready
to hand.
 The energy-saving outdoor spotlight may be mounted only on stable substrates, for example,
brickwork.
 Do not install the energy-saving outdoor spotlight above a heat source or in the immediate vicinity of
other light sources. When selecting the installation location, also pay attention to the illustration [D] on
the inside cover.
 Select the installation location so that the energy-saving outdoor spotlight is protected against wind,
rain and dirt.
 Find out in advance which installation material is suitable for the installation location you selected.
Suitable installation material for concrete is included with the energy-saving outdoor spotlight.

Required tools

The following tools are not supplied. This list can be used for orientation. The exact nature of the required
tools depends on the individual on-site conditions.
 Ladder
 Voltage tester
 Spirit level, folding ruler, pencil
 Drill with drill bits
 Phillips screwdriver, flat-bladed screwdriver
 Spanner, combination pliers, side cutter

Prior to installation

The installation must be performed only by an authorised electrician!
The circuit must be disconnected during the installation!
When drilling the holes, make sure that no cables or pipes in the wall are damaged.
LIVARNO LUX LLES B2
English - 7