Before Installation - LIVARNOLUX IAN 298451 Montage-, Bedienungs- Und Sicherheitshinweise

in the safe use of the product and understand
the associated risks. Children should not be
allowed to play with the product. Cleaning
and user maintenance should not be per-
formed by children without supervision.
DANGER OF SUFFOCATION! Children
could swallow and choke on small included
parts (e.g. screws). Keep children away from
the work area during assembly.
This product does not contain any parts that
can be serviced by the user. The LEDs cannot
be replaced by end user.
If the LEDs fail at the end of their lives, they
must be repaired by qualified electrician or
the entire product must be replaced.
Danger to life
by electric shock
Always check the product for damage before
connecting it to the mains. Never use the
product if it shows any signs of damage.
Prior to installation, verify that the mains volt-
age on site corresponds with the operating
voltage required for the product (230 V∼
50 Hz). Otherwise do not install the product.
CAUTION! DANGER OF BURN INJU-
RIES! To prevent burns, verify the product is
switched off and has cooled down for at
least 15 min before touching it. The product
can become very hot.
FIRE HAZARD! Fit the product
so that it is at least 1.0 m away
1 .0 m
from the material to be illuminated.
Excessive heat can result in a fire.
8 GB/IE/NI
The product is only suited for use with the
built-in LED control gear.
The product continues to draw a small
amount of power even if the product is off as
long as product is connected to supply
mains. To switch the device off completely,
the mains switch should be switched off.

Before installation

Note: Remove all packaging materials from the
product.
Important: The electrical connection must be
established by a qualified electrician or a person
trained to perform electrical installations. This per-
son must be familiar with the properties of the
product and the connection regulations.
Before installation ensure that the circuit, to
which the product will be connected, is not
energised. To do so, remove the fuse or switch
off the circuit breaker in the fuse box (0 posi-
tion).
Use a voltage tester to verify the de-ener-
gised status.
The included mounting material (screws
and wall plugs
3
solid concrete or masonry construction. Check
which mounting material is suitable for your
chosen mounting surface. If necessary, seek
expert advice.
) is suitable for ordinary
1