Installation - LIVARNOLUX HG01495A Montage-, Bedienungs- Und Sicherheitshinweise

Installation

When selecting the mounting location, pay attention to the
following:
Note: The included mounting material is suitable for ordinary
solid concrete or masonry construction. Other wall substrates may
require other fastening materials. Seek specialist advice if necessary.
Note: You will need an electric drill.
CAUTION! RISK OF INJURY! Please read the operating
instructions for your drill.
CAUTION! Ensure that you do not damage any electricity cables
in the wall or ceiling.
1. Make sure the LED spotlights
can move the LED spotlights
2. Depending on the mounting height (ideally at 2 m) the motion
detector
angle of 140° horizontally and 90° vertically.
3. Be sure the motion detector is not illuminated by street lighting at
night. This can influence the effect.
Loosen the screw on the bottom of the main unit
cross-head screwdriver. Remove the mounting plate
back of the product (Fig. A).
Pay attention to the battery compartment cover
Use the holes of the mounting plate
mark the holes for drilling. Ensure that the arrow on the marking
of the mounting plate is showing vertically upward.
Now drill the mounting holes.
Insert the wall plugs
12 GB/CY
has a detection range of max. 8 m with a detection
3
into the drilled holes (Fig. B).
6
illuminate the desired area. You
2
independently in various directions.
2
intended for the screws to
5
with a suitable
1
from the
5
.
8