Before Installation; Installation - LIVARNOLUX HG00108A Montage-, Bedienungs- Und Sicherheitshinweise

by the user. The LEDs cannot
be replaced.
The spotlight is only suited for
use with the built-in LED control
gear.
The product continues to draw
a small amount of power even
if the lamp is off as long as
product is connected to supply
mains. To switch the device off
completely, the mains switch
should be switched off.

Before installation

Important: The electrical con-
nection must be established by a
qualified electrician or a person
trained to perform electrical instal-
lations. This person must be familiar
with the properties of the light and
the connection regulations.
Before installation ensure that
the circuit, to which the light will
be connected, is not energised.
To do so, remove the fuse or
switch off the circuit breaker in
the fuse box (0 position).
Use the voltage tester to verify
the de-energised status.
The included mounting material
is suitable for ordinary solid
concrete or masonry construc-
tion. Check which mounting
material is suitable for your
chosen mounting surface. If
necessary, seek expert advice.

Installation

When selecting the mounting loca-
tion, pay attention to the following:
Make sure that the spot
illuminates the desired area. You
can move the spot vertically.
Make sure the motion detector
covers the desired area. The
7
motion detector has a maximum
coverage range of 12 m, with a
coverage angle of about 180°
(depending on the mounting
height – a height of 2.50 m is
ideal) (Fig. D).
Make sure the motion detector
is not illuminated at night by
street lighting. This can influence
its functioning.
1
GB/MT 35