5
Connecting
5.1
Incorrect mounting
NOTICE
Incorrect mounting
The device can be damaged, destroyed, or its functionality impaired through improper mounting.
● Before installing ensure there is no visible damage to the device.
● Make sure that process connectors are clean, and suitable gaskets and glands are used.
● Mount the device using suitable tools. Refer to the information in Chapter "Technical specifications (Page 16)", for
example installation torques requirements.
Prerequisites
You need the EMC filter module with Order No. C73451-A430-D23 to connect the NTC to the positioner. The positioner
supplies auxiliary power to the NTC via the EMC filter module.
For installation and connecting instructions for the EMC filter module, refer to the positioner operating instructions, chapter
"Installing/Mounting" and to chapter "Connecting".
Connection diagram
①
Positioner (open state)
②
Vcc: Yellow
③
Vref: Green
④
Vpos: Black
⑤
Ground: Brown
14
⑦
Cable clamp
⑧
Screw F3x8
⑨
Cable bushing
⑩
Four-pole NCS cable
⑪
Non contacting sensor (NCS)
SIPART PS2 Non Contacting Sensor (NCS)
A5E00097485-08, 07/2012