Siemens SIPART PS2 Kompaktbetriebsanleitung Seite 10

Procedure for part-turn actuators with manufacturer-specific interface
1. Steps 1 to 4 as above.
2. Set a clearance of 3 mm between the top edge of the magnet
the stub shaft accordingly, or insert washers underneath the NCS housing
Reference
For information on the scope of delivery, refer to chapter "Scope of delivery of NCS for part-turn actuators (Page 19)".
4.2 Mounting the NCS to a linear actuator up to 14 mm (0.55 inch)
Prerequisites
1. An EMC filter module in the positioner.
2. An NCS for linear actuators up to 14 mm (0.55 inch) 6DR4004-.N.20.
3. Linear actuator with interface to NAMUR. This installation must be carried out individually. Only a NAMUR mounting
bracket can be used as mounting base. The following figure shows the assembly with NAMUR mounting bracket.
Or
linear actuator without interface to NAMUR and individual mounting solution.
Description
Dimensions in mm
A Mounting on a yoke with fin
B Mounting on a yoke with plane surface
C Mounting on a yoke with columns
①
NAMUR mounting bracket IEC 60534 - not
included in the scope of delivery
10
③
and the top edge of the mounting console
⑫
.
②
Assembly panel for Non Contacting Sensor (NCS) -
individual solution; not included in the scope of delivery
③
Non contacting sensor (NCS)
④
Magnet
⑤
Mounting bracket for the magnet - individual solution;
not included in the scope of delivery
SIPART PS2 Non Contacting Sensor (NCS)
A5E00097485-08, 07/2012
⑨
. Extend