Siemens SIPART PS2 Kompaktbetriebsanleitung Seite 11

Figure 4-2 Example of the assembly on a linear actuator with a stroke up up to 14 mm (0.55 inch)
Procedure
1. Produce the mounting panel
2. Align the sensor to the center of the stroke. Observe the dimensions specified in the figure.
Reference
For information on the scope of delivery, refer to chapter "Scope of delivery of NCS for linear actuators up to 14 mm
(0.55 inch) . (Page 19)".
4.3 Mounting the NCS to a linear actuator > 14 mm (0.55 inch)
Prerequisites
1. An EMC filter module in the positioner.
2. An NCS for linear actuators > 14 mm (0.55 inch) 6DR4004-.N.30.
3. Linear actuator with interface to NAMUR
Order no. based on the respective stroke range: 6DR4004-8V or 6DR4004-8V + 6DR4004-8L.
Or
linear actuator without interface to NAMUR and individual mounting solution. Order No. 6DR4004-8VK or 6DR4004-8VL
can be sued as individual assembly solution, depending on the stroke range.
SIPART PS2 Non Contacting Sensor (NCS)
A5E00097485-08, 07/2012
②
and mounting bracket
⑤
individually.
11