Air Filter Cleaning - Husqvarna TE 630 2011 I.E. Merkmale, Gebrauch, Wartung

AIR FILTER CHECK
- Insert the key in latch (1) then turn clockwise to re-
lease the saddle lock; remove the saddle.
- Disengage rear right-hand side panel (2) from filter
cover then slide it toward vehicle front.
- Loosen the seven screws (3) and remove the filter
cover (4).
Note *:
The screws have a different length, it is recommended
to mark them in order to favour correct reassembly.
- Remove the filter (5) together with support frame.
- Slide out the filtering element (6) from the support
frame (7).
3
1

AIR FILTER CLEANING

2
Wash the filter with a specific detergent (CASTROL FOAM
AIR FILTER CLEANER or similar) then dry it fully (wash
filter with gasoline only in case of need). Plunge the filter
in special oil for filters (CASTROL FOAM AIR FILTER OIL or
similar), then wring it to drain superfluous oil.
WARNING*: Do not use fuel or a low
flash-point solvent to clean the filter-
ing element. A fire or explosion could
result.
WARNING*: Clean the filtering element
in a well ventilated area and do not al-
3
low sparks or flames anywhere near
the working area.
4
3
5
6
7
EN - 27