Starting The Engine - Husqvarna TE 630 2011 I.E. Merkmale, Gebrauch, Wartung

STARTING THE ENGINE

With cold engine, i.e., after the motorcycle has not
been used for a while or in low ambient temperatures,
operate in the following manner:
1) Place ignition key (1) to ON position (the buzz that
you hear when you turn the key to ON is caused by
the fuel pump which puts the feeding system under
pressure);
2) pull the clutch lever (3);
3) pull the starter lever (2);
4) shift gear pedal (4) to neutral position then release
the clutch control level;
5) Check that the button (5) is in the out position and
press it, followed by the start button (6). Bring the
starter lever (2) back to its original position as soon
as the motor can idle. When starting with an al-
ready warmed up engine DO NOT USE the starter.
When a cold engine has just been started, do not
increase revs, to ensure an adequate oil warm-up
and circulation.
Note *:
A safety switch is set on the clutch lever support. This
switch allows you to ONLY start the engine with the
gearbox idle, or with the gear engaged and the clutch
lever pulled.
2
3
N
4
5
1
6
EN - 19