Disc Cleaning; Appendix - Husqvarna TC 250 2012 Bedienungsanleitung

DISC CLEANING

Poor braking can also be caused by oil on the disc. Oil or grease
on the disc must be cleaned off with a high flash-point oil free
solvent, such as acetone or lacquer thinner.
EN - 38 SPECIFICATIONS - OPERATION - MAINTENANCE
EXHAUST MUFFLER
The muffler reduces the noise of the exhaust gases, but it is an
integral part of the exhaust as well. As such, its conditions affect
the motorcycle performance.
When the noise on the exhaust is too high, it means that the
deadening material set on the holed tube inside the muffler
is deteriorated.

APPENDIX

AFTER-RACE CHECK POINTS
After racing, first clean the motorcycle and then inspect the
entire motorcycle, with special attention to the items listed in
«MAINTENANCE» table (Appendix A), such as the air cleaner,
carburetor, brakes, etc.
Carry out general lubrication, and make adjustment as neces-
sary.
- Lubricate the drive chain and all the cables.
- Spray oil on all unpainted metal surfaces to prevent rusting.
Avoid getting oil on rubber parts or in the brakes.
- Set the motorcycle on a box or stand so that both wheels are
raised off the ground. (If this cannot be done, put boards un-
der the front and rear wheels to keep dampness away from
the tire rubber).
- Tie a plastic bag over the exhaust pipe to prevent moisture
from entering.
- Put a cover over the motorcycle to keep dust and dirt from
collecting on it.
To put the motorcycle back into the use after storage.
- Make sure the spark plug is tight.
- Fill the fuel tank.
- Run the engine to warm the oil then drain the oil.
- Put in fresh transmission oil.
- Check all the points listed under the inspection and Adjust-
ment Section (Appendix A).
- Lubricate the points (listed in the Lubrication Section (Appen-
dix A).