Husqvarna TE 630 2011 I.E. Merkmale, Gebrauch, Wartung Seite 108

HEADLAMP BULBS REPLACEMENT
Proceed as follows to reach the headlamp bulbs:
- pull out the front fairing (1) to remove it;
- loosen the three screws (2) and remove the headlamp
(3);
- detach connector (4) from the bulb;
- slide off the rubber gaiter (5);
- release the bulb holder clips (6) and take out bulb (7);
2
EN - 50
Note*:
Headlamp bulb (7) is of the halogen type; be care-
ful when replacing it since the glass part shall not be
touched with bare hands.
To replace the parking light bulb (8) extract it from the
inside cover.
After replacement, reassemble any removed parts mak-
ing sure to set the centre of side screws (2) at the notch
(C) on the support.
C
2
4
1
6
2
2
7
3
8
5