CARPI C 34 DS Gebrauchsanleitung Seite 39

MAINTENANCE AND CHECK
ELEMENT
Machine complete
Throttle lever
Stop button
Carburettor
Carburettor area
Cutting tool
Tank
Head with gears area
Guard
Head with gears
Nuts, screws, bolts (not adjusters)
Air filter
Air vents
Cylinder fins
Spark plug area
Spark plug
Cables and connections
Springs and clutch pads
Petrol filter
For flex brush cutters only
WARNING Read the Safety measures chapter of this manual very carefully.
Before carrying out any repairs or maintenance work, remove the spark plug cap.
PROCEDURE
Visual check
Clean
Operational check
Operational check on the safety
lever. If it is not pressed, then the
throttle command will not work.
Operational check
Check that the tool does not turn
with the motor at minimum rpm
Clean
Adjust
Clean
Visual check (breakage, cracks,
poor alignment, eccentricity etc.)
Check tightness
Check for
fuel leaks
Clean
Clean, remove any grass
Visual check
Lubricate with lithium-based grea-
se. Remove the screw and fill with
grease, turning the head manually
until the grease comes out (Fig.
26). Refasten the screw.
Check tightness
Check
Clean with brush, hot water and
soap or another non-flammable
liquid detergent. Leave to dry and
then refit (Fig. 27).
Clean
Clean
Clean
Check and clean the spark plug of
any excess carbon (Fig. 28).
Measure the distance between elec-
trodes and replace if necessary.
Check
Check and replace if necessary
Check and replace if necessary
(Fig. 29)
Remove the flexible shaft from the rubber
sleeve and lubricate the shaft thoroughly
with lithium-based grease (Fig. 30)
GB
FREQUENCY
39