Renishaw REVO-2 Handbuch Seite 30

REVO-2 user's guide
www.renishaw.com
Manually mounting / removing the stylus
from stylus holders
1. The stylus holder must be removed from the probe before mounting / removing a stylus.
2. Always use the correct stylus tools to tighten and undo the threaded joints between the stylus and the stylus holder, thus avoiding excess
torque (see diagram below).
NOTE: If a spare stylus removal tool is needed order Renishaw part A-5000-7835 (the set comprises two S7 stylus tools in a plastic
box).
CAUTION: Failure to use two tools as shown is likely to break the stylus holder.
Issued 10 2019
30