Renishaw REVO-2 Handbuch Seite 26

REVO-2 user's guide
www.renishaw.com
REVO-2 probe specification
Used for
Stylus range
Cranked styli
Crash protection
Calibration
* All scans should be configured to allow an angle no greater than 45° between the measured surface and the axis of the RSP2 or RSP2 V2
probe.
** For more detail refer to UCCserver 5.0 (or newer) or PBC-01909.
NOTES: For optimum metrology, it is essential that all probe and stylus holder changes are carried out automatically through the
appropriate change ports.
Avoid touching the joint faces, as they will become contaminated. It is vital that the joint surfaces are protected and stay clean.
Replace covers when not in use.
Issued 10 2019
RSP2 and RSP2 V2
High-speed 5-axis 2D scanning *
and single point taking
M2 but range has been selected
to opimise high speed scanning
performance **
No
XY and –Z via break off of either
module or stylus holder, +Z via
integral bump-stop design
Uses Ø30 mm sphere supplied
with REVO‐2 or optional Ø45
mm sphere
RSP3-x
3-axis traditional CMM scanning
and single point taking
M3
Yes
XY and –Z via break off of either
module or stylus holder, +Z via
integral bump-stop design
Uses Ø30 mm sphere supplied
with REVO‐2 or optional Ø45
mm sphere
SFP2
Surface finish measurement
SFS-#
SFM-#
Yes
XY and –Z via break off of holder
Uses SFA# and TFP
26