Renishaw REVO-2 Handbuch Seite 29

REVO-2 user's guide
www.renishaw.com
Manually mounting / removing the probes
from REVO-2
To manually mount the probe to the REVO-2 head:
1. Align the front sides of the head and probe with each other (look at the "Renishaw" engraving on the side of probe or alignment marks, as
applicable).
2. Carefully offer up the probe to the REVO-2 head, allowing the magnetic attraction to gently make the kinematic joint; also gently attempt to
rotate the probe to ensure correct location.
To manually remove the probe from the REVO-2 head:
1. Securely hold the probe.
2. Gently tilt to break the kinematic joint and separate.
Issued 10 2019
29