Starting The Engine; Cold Start; Warmstart - Parkside PBS 2 A1 Originalbetriebsanleitung

GB MT
The carrying harness is
equipped with a quick-re-
lease device. Pulling the red
lug (37) releases the device
quickly from the carrying har-
ness in a dangerous situation.
1. Put on the carrying harness (26). The
clip must be situated on the chest.
2. Adjust the strap so the spring clip is
around 10 cm below the hip.
3. Fix the spring clip onto the lifting ring
(9) on the shaft tube of the equipment.
Unhook the device before starting the
engine and fasten it to the carrying
harness once the engine is running.
Place the protective body (27) on
your hip between your body and
the device.

Starting the Engine

Start the engine at least three
metres from the illing location
Place the appliance on a solid and
even surface. Check that the blade is
not touching any objects or the ground.

Cold start:

1. Make sure that the protective cap on
the thread cutter (
2. Place the device on a irm level sur-
face. Make sure that the cutting tool
does not touch either other objects or
the ground.
3. Set the choke lever (3) to position
4. Press the fuel pump (primer) (
times.
5. Set the on/off switch (20)
to position .
6. Hold the device irmly with one hand
64
14) is removed.
A
5) 6
A
by the upper shaft tube (8). With the
other hand, pull the starter cable on the
starter handle (4) quickly several times
in succession until the engine starts and
then switches off again after around
one section.
Caution! Do not pull the starter
cable out too far - Danger of
breakage!
8. Set the choke lever (3) to the warm
start position
cable once again to start the strimmer.
The device is now idling.
7. To mow, keep the throttle lock (21)
pressed down and operate the throttle
(22). When the throttle is oper-
ated, the choke lever (3) auto-
matically jumps into the warm
start position
8. To switch off the engine, set the on/off
switch (20) to position 0 .
Warm start:
1. Leave the choke lever (3) in its present
position
2. Hold the device irmly with one hand
by the upper shaft tube (8). With the
other hand, pull the starter cable on
the starter handle (4) quickly several
times in succession until the engine
starts.
Caution! Do not pull the starter
cable out too far - Danger of
breakage!
The device is now idling.
3. To switch off the engine, set the on/off
switch (20) to position 0 .
. If the engine has not started after
two attempts, try a warm start wi-
thout the choke in the warm start po-
sition. If this is not successful, follow
the instructions in the „Troubleshoo-
ting" section.
and pull the starter
.
.