Connections And Controls; Installing The Device; Fastening The Device - Dometic SMP 439A Montage- Und Bedienungsanleitung

SMP439A
5.1

Connections and controls

No. in
fig. 1, page 3
1
2
3
4
6

Installing the device

6.1

Fastening the device

When selecting the installation location, observe the following instructions:
•
The device should be installed vertically.
•
Do not install the device
– In wet or damp environments
– In dusty environments
– In the vicinity of combustible materials
– In areas where there is a danger of explosions.
•
The place of installation must be well ventilated. A ventilation system must be
available for installations in small, enclosed spaces. The clearance around the
device must be at least 25 cm.
•
The air inlet on both short sides of the device must remain clear.
•
For ambient temperatures higher than 40 °C (such as in engine or heating com-
partments, or direct sunlight), the heat from the device under load can lead to
reduced output.
•
The device must be installed on a level and sufficiently sturdy surface.
•
Do not install the device in the same area as the batteries.
•
Do not install the device above batteries, because they can emit corrosive sul-
phur fumes that will damage the device.
A
NOTICE!
Before drilling any holes, make sure that no electrical cables or other
parts of the vehicle can be damaged by drilling, sawing and filing.
EN
Explanation/function
Input for AC power supply
Status LED
Battery type selector button
Battery connector
Installing the device
13