Installation And Connection Of The Carburetor; Installation Of The Bowden Cable For Carburetor Control - Rotax 125 MAX DD2 evo Betriebsanleitung

 Attention: The flow in the impulse hose and fuel lines must not be restricted by the use of
cable ties.
 Attention: The use of an extra fuel filter must not cause further flow resistance in the fuel line
between the fuel tank and the fuel pump.
7.2.

Installation and connection of the carburetor

See Fig. 20.
 Remove the transport plug from the carburetor.
 Fit carburetor (pos. 1) into carburetor socket and secure with hose clamp (pos. 2) in
vertical position.

Connect the outlet hose of the fuel pump with fuel inlet on carburetor (pos. 3).
8.

Installation of the Bowden cable for carburetor control

See Fig. 21.
 Carefully remove carburetor cover with rubber ring (pos. 7, 8)
 Attention: Reset spring (pos. 6) of carb piston presses against carburetor cover and might
eject carburetor cover at removal.

Remove nipple screw (pos. 5) with A/F 10 wrench from carburetor piston (pos. 2).
 Engage nipple of Bowden wire (pos. 9) in nipple screw (pos. 5).
 Fit nipple screw in carburetor piston and hand tighten with A/F 10 wrench.
 Insert carburetor piston (pos. 2) into carb body with cut-away of piston towards
intake silencer.
 Pass Bowden wire through compression spring (pos. 6) and through cover with
rubber ring (pos. 7, 8) of carburetor.
 Fit carb cover (pos. 7) on carburetor.
Seite/page 68/98
Installation Instructions 125 MAX DD2 evo
Fig. 20
Ausgabe/Edition 11/2014