2.9.
Push-assistance
The push-assistance is acti vated by pressing the
"Walk butt on" and the "+" butt on one aft er the
other. The "Walk" butt on is located above the "+"
butt on.
The push-assistance helps you to push the pedelec
at a maximum of 6 km/h (in the highest gear).
In smaller gears the speed is lower.
2.10. Bedding-in brake pads
When delivered, your brake system initi ally only has a weak braking eff ect, as the
surfaces of the brake disc and brake pads have not yet been used for braking. With
your new vehicle and also if you change the brake disc and brake pads, you should
bed-in the disc brakes as follows:
•
Accelerate the vehicle to approx. 25 km/h
•
Decelerate to a stop using both brakes
•
Repeat the procedure unti l the braking eff ect improves suffi ciently. Recommen-
dati on for the Magura: 30x.
Risk of roll-over when using the front wheel brake forcefully!
You can go over the handlebar!
-> Apply less force to the left brake lever or release the brake lever when
you noti ce the rear wheel rising.
2.11. Installing the mirror (only Speed Pedelec)
•
Push a fl at screwdriver/table knife between the left handlebar plug and the
clamp ring and prise the handlebar plug out
•
Loosen the screw of the clamp cone with an Allen key.
•
Push the clamp cone of the mirror into the
left handlebar end.
•
Align the mirror and ti ghten the screw of the
clamp cone with an Allen key so that the
mirror cannot be inadvertently displaced
while riding.
Commissioning
81