Suspension Fork Setup - HNF-NICOLAI XD3 All-Terrain Originalbetriebsanleitung

Commissioning
To change the saddle height, proceed as follows:
• Loosen the screw of the seatpost clamp with an Al-
len key unti l you can adjust the saddle height.
• Then reti ghten the screw to a torque of approx.
14 Nm.
The screw of the seatpost clamp is ti ghtened enough when the seatpost
cannot be turned or when it no longer slides down into the seat tube under
your weight.
If you pull the seatpost out too far, the upper part of the seat tube may
break. There is a risk of accident or injury!
-> Pull the seatpost out only unti l the minimum inserti on depth mark is
just visible.
2.4.

Suspension fork setup

XD3 (Air suspension fork)
You can tune the RockShox suspension fork to your weight and therefore need a
small volume damper or suspension fork pump. This is not included in the delivery.
First, read the recommended pressure for your weight on the label on the left tube
of casti ng. You may need to convert the pressure to your weight.
• Unscrew the cap on the top left of the crown.
• Screw on the damper or suspension fork
pump and read the existi ng pressure.
• Increase or decrease the pressure to the
pressure determined for you.
• Unscrew the pump.
Now check the travel (SAG) used by your body weight.
This should be 18-30 mm.
• Wind a cable ti e around a stanchion of the suspension fork.
• Place the vehicle next to a wall.
• Climb on gently and take the normal riding positi on. For stability, you can lean
against the wall.
78