Routine Maintenance; Special Maintenance - Comet HOT BOX serie Betriebs- Und Wartungsanleitung

• The burner starts after about three seconds from when the spray gun is opened and stops operating
when the spray gun is closed or when the set temperature has been reached.
• In case of the flame going out the burner stops and the indicator (20) lights up.
• Run the equipment with cold water for a couple of minutes.
• Move the master switch (1) to "0" position.
• Remove the plug from the power socket, or disconnect the poles from the battery (12 V
• Close securely the water supply tap of the combined high-pressure cleaner (or take the suction pipe out
of the supply tank).
• Empty the water out of the combined high-pressure cleaner by pressing the lever on the spray gun for
a few seconds.
• Stop the combined high-pressure cleaner, making reference to the relative instruction manual.
• Press the lever on the spray gun for a few seconds to discharge any remaining pressure in the high-pressure
hoses.
• Wait for the combined high-pressure cleaner and the equipment to cool down.
• Wind up the high-pressure hose (21) carefully, without any bends and hang it to its support (8)
(HOTBOX 15/200) or the handlebar (2) (other models).
• Wind up the power cable (6) carefully and hang it to its support (8) (HOTBOX 15/200) or the handlebar (2)
(other models).
• Carefully store the equipment in a dry, clean place, taking care not to damage the power cable or the
high-pressure hose.
• Also follow the instructions for decommissioning given in the instruction manual of the combined high-
pressure cleaner.
Carry out the operations described in the "STOP" section, following the indications given in the table below.
MAINTENANCE SCHEDULE
After every use
Once a month
Special maintenance jobs must only be performed by a SKILLED TECHNICIAN, complying with the
following table (approx. data):
MAINTENANCE SCHEDULE
Every 200 hours.
Every 500 hours.
28
STOP
DECOMMISSIONING

ROUTINE MAINTENANCE

• Check any power cable, high-pressure hose, fittings.
In the event of one or more parts being damaged, do not use the
equipment and contact a SKILLED TECHNICIAN.
• Clean the diesel fuel fill up filter (30).
Unscrew the diesel fuel tank cap (7) to access the fill up filter. Take out
the filter and remove any impurities. In the most difficult cases, replace
the filter. For spares, contact a SKILLED TECHNICIAN.

SPECIAL MAINTENANCE

• Adjust the electrodes.
• Replace the electrodes.
• Replace the diesel fuel nozzle.
• Clean the boiler.
JOB
JOB
• Clean the diesel fuel nozzle.
• Check/replace the diesel fuel filter.
• Descale the coil.
• Check the safety devices.
models).