Standard Equipment - Comet HOT BOX serie Betriebs- Und Wartungsanleitung

Vorschau ausblenden

Inhalt

Inhaltsverzeichnis

Verfügbare Sprachen

• Perform the checks required by routine maintenance.

• The equipment must be protected against freezing: if it is not possible to protect this way, before starting

it, take it to a warm environment for long enough to melt any ice inside. Failure to do so could cause

serious damage to the equipment.

• If the equipment is used above 1000 m/3281 ft of height, contact a SKILLED TECHNICIAN for a check

and a possible combustion adjustment.

• The use of agricultural, heating or dirt diesel fuel causes excessive deposits onto the burner, thus impairing

its good operation.

• After use, before performing the "STOP" procedure, run the equipment with the burner off for a few

minutes so as to cool down the delivery circuit.

Make sure that the product purchased consists of the following elements:

• mobile boiler;

• high-pressure connection hose to the combined high-pressure cleaner;

• instruction book;

• rotating coupling (27) for connecting to the high-pressure cleaner M22x1,5 (HOTBOX 25/350 only);

• water outlet fitting M22x1,5 (29) (HOTBOX 25/350 only);

• declaration of conformity;

• warranty certificate;

• booklet giving the service centres.

If there are any problems, contact the Manufacturer or an authorized service centre.

• Using a 22 mm/0.86 in hexagon spanner, tighten the coupling (26) to the fixed coupling (25) (HOTBOX

25/350 only). Operation C in Fig. 5.

• Using two 22 mm/0.86 in hexagon spanners, replace the coupling (22) with the coupling (27) (HOTBOX

25/350 only with combined high-pressure cleaner with max pressure up to 200 bar/2900 psi). Operation B

in Fig. 5.

WARNING

• The following operation must only be performed by a SKILLED TECHNICIAN.

• Contact a SKILLED TECHNICIAN to replace the fitting (28) with the fitting (29) (HOTBOX 25/350 only

with combined high-pressure cleaner with max pressure up to 200 bar/2900 psi). Operation E in Fig. 6.

• Connect the coupling (23) to the coupling (24), tightening well (HOTBOX 25/500 only). Operation D

in Fig. 5.

• Making reference to the indications in the relative instruction manual, take the combined high-pressure

cleaner to the workplace and engage any parking brake.

• Move the equipment to the workplace by means of the handlebar (2). If fitted, engage the brake (15) of

the swivel wheel (14).

• Making reference to the indications in the relative instruction manual, connect the combined high-pressure

cleaner to the water supply.

• Completely unwind the high-pressure hose (21) connecting the combined high-pressure cleaner to the

equipment and the delivery hose (32) of the high-pressure cleaner.

• Connect the high-pressure hose (21) to the outlet of the combined high-pressure cleaner. Operation F

in Fig. 7.

• Connect the delivery hose (32) of the combined high-pressure cleaner to the equipment outlet.

Operation G in Fig. 7.

• Making reference to the indications in the relative instruction manual, connect the spray gun to the