Installation - Panasonic AK-UB300G Bedienungsanleitung

Installation

Securely fix to the camera housing, the pan/tilt head, or the tripod using the mounting screw holes at the
top and bottom.
Always use tools when installing and confirm that there is no danger of drop.
16 mm (21/32 inch)
NOTE
@
t Always use an anchor bolt when installing the mounting fixture into the ceiling or the wall.
Secure drawing strength of ten times or larger against the entire weight including the mounting fixture,
camera, lens, and cables.
t Always take the drop prevention measure using the screws on the tripod when mounted on a tripod.
t The weight including the camera body, lens, and cables should be 4 k] or less.
t Attach the drop prevention wire so the distance of drop will be 300 mm (11 13/16 inches) or less.
t Tighten the mounting screws with the following torques, and confirm that there is no rattling.
- 1/4 inch screw: 2.0 N·m (20 k]f·cm)
- 3/8 inch screw: 12 N·m (120 k]f·cm)
- M4 screw: 1.0 N·m (10 k]f·cm)
t Do not use impact driver. Doing so may damage the screws.
40.5 mm (1 5/8 inches)
Drop prevention wire mounting screw hole (M4)
40.5 mm (1 5/8 inches)
50.8 mm (2 inches)
14 mm (9/16 inch)
Mounting screw holes
(1/4-20 UNC)
Mounting screw holes
(1/4-20 UNC)
Mounting screw holes
(3/8-16 UNC)
Installation
11