Before Installing; Drop Prevention Measure - Panasonic AK-UB300G Bedienungsanleitung

Before installing

Before installing

Drop prevention measure

Take the drop prevention measure by attaching the drop prevention wire to the mounting screw hole.
Mounting the camera to the pan/tilt head
Prepare a commercially available drop prevention wire when mounting this unit to the pan/tilt head.
Mounting the camera to anything other than the pan/tilt head
Prepare the drop prevention wire and camera mounting fixture when attaching to anything other than the
pan/tilt head.
1 Drop prevention wire (optional): 1
Always use the drop prevention wire.
A drop prevention wire is available as an optional accessory. Use with as small slack as allowed by the
installation location or the installation method.
Secure wire diameter of 2 mm or more, length of 300 mm (11 13/16 inches) or less, and strength of the
mounting section of 2000 N or more when using a commercially available drop prevention wire. Also,
separately prepare the mounting screw matching the mounting specification.
Camera side
f Wire length 300 mm (11 13/16 inches): Parts number (DVDW1001ZA)
2 Camera mounting screws (procured locally): 2
Size: 1/4-20 UNC or 3/8-16 UNC
Consider the thickness of the camera mounting fixture for the length.
3 Installation side wire mounting screw (M6 or M4) (procured locally): 1
Use an anchor bolt at the installation location and secure the strength of ten times of the entire weight.
4 Flat washers (procured locally): 2 (for mounting the camera)
For 1/4 inch screw or 3/8 inch screw
5 Spring washers (procured locally): 2 (for mounting the camera)
For 1/4 inch screw or 3/8 inch screw
6 Camera mounting fixture (procured locally): 1
Prepare the fixture with material and shape that can withstand the entire weight of the camera and the
lens.
10
Length of the wire (300 mm) (11 13/16 inches)
6.4 mm
4.5 mm
2 mm
Camera mounting fixture
7–9 mm
6.4 mm
4.5 mm
Installation side
11 mm