Precautions For Installation - Panasonic AW-E750E Bedienungsanleitung

PRECAUTIONS FOR INSTALLATION

Concerning the mounting screws and drop-prevention wire
Attach the drop-prevention wire as a way to prevent
the camera from dropping.
p When the unit is to be mounted onto a Panasonic
pan-tilt head, use the mounting screws and drop-
prevention wire that are supplied with the pan-tilt head.
p When the unit is to be mounted onto a surface other
than a pan-tilt head, provide your own drop-prevention
wire and camera mounting bracket. For details of the
parts to be provided, refer to page 11.
p Attach the drop-prevention wire to the camera mounting
screw hole (Inch screw).
The camera cannot be installed or used in the
following locations.
p Outdoor locations and locations where the camera may
be exposed to dripping, splashing or sprayed water
p Locations such as swimming pools where chemicals are
used
p Locations such as a kitchen where the high levels of
steam and oily vapors are present and locations with
flammable atmospheres or other unusual conditions
p Locations where radioactive rays, X-rays or strong radio
waves or magnetic fields are generated
p Locations where the temperature may be outside the
camera's operating ambient temperature (–10 °C to
45 °C) range
p Locations near the air outlet of an air conditioner or near
a door where the camera will be exposed to incoming
The connection and installation should be done by
qualified service personnel or system installers.
Refer any servicing to qualified service personnel.
outside air or other locations where the temperature is
subject to sudden change (since these locations may
cause the lens area to cloud over and/or condensation
to form)
p Locations that are subject to significant vibration, such
as on top of a car
p Locations with high levels of humidity or dust
When the camera is not going to be used, do not leave
it in place but be absolutely sure to remove it from its
mounting, and put it away.
Do not run the camera cable near the wiring of electric
lights.
This may result in noise interference.
Concerning electromagnetic interference
The camera's images may become distorted or noise
interference may result if the camera is used near a TV
or radio transmission antenna or in strong electrical or
magnetic fields (such as one generated by motors,
transformers, etc.).
Using outdoors
The camera is designed to be used indoors.
When using outdoors, be absolutely sure to use the
AW-PH650 outdoor pan-tilt head.
- 9 (E) -