Panasonic AK-UB300G Bedienungsanleitung Seite 47

5 <LAN> terminal
Used to connect the LAN cable.
@ NOTE
t Use a shielded cable when connecting a cable to the <LAN> terminal.
6 <WARNING> lamp
This will illuminate in red when a problem occurs.
7 <IRIS> terminal
Used to connect the lens iris control cable.
8 <TALLY OUT> terminal
Outputs R tally and G tally.
9 <ZOOM/FOCUS> terminal
Used to connect the lens zoom/focus control cable.
10 <HD SDI OUT 1> terminal
This is the main line output terminal dedicated for HD SDI.
@ NOTE
t Use a cable that is 5C-FB or above.
11 <G/L IN> terminal
This is the reference signal input terminal when applying external synchronization to the camera.
@ NOTE
t Supply a composite signal (black burst) or a tri-level SYNC as the input signal.
12 <HD SDI OUT 2> terminal
This is the monitor output terminal dedicated for HD SDI.
@ NOTE
t Use a cable that is 5C-FB or above.
13 <DC IN> lamp
This will illuminate in green when power is supplied to the camera.
14 <DC IN> terminal
This is an input terminal for the external DC power supply. Connects to the external DC power supply.
(DC 11 V to 17 V)
For details, refer to "Using external DC power supply" (page 18).
15 <UHD/HD SDI OUT 1>/<UHD/HD SDI OUT 2>/<UHD/HD SDI OUT 3>/<UHD/HD SDI OUT 4>
terminal
These are the UHD and HD SDI main line output terminals.
@ NOTE
t Use a cable that is 5C-FB or above.
Description of parts
47