Storage; Troubleshooting - Silvercrest SFE 450 C1 Bedienungsanleitung

GB

Storage

Troubleshooting

Faults
The appliance is
not working.
The motor stops
still while juicing or
it turns noticeably
more slowly or
unevenly.
The pulp is moist
and you obtain too
little juice.
12
To clean the filters , use the supplied nylon brush
■ Turn the lid of the pusher
the pusher shaft. You can now remove the lid. The nylon brush
found inside the pusher
the arrow points to the opened lock
the closed lock . The lid now sits firmly in place.
■ Hold the filter (with the underside upwards) under running water and
clean it with the nylon brush
Colouring:
■ Some fruits or vegetables can permanently discolour parts of the juicer.
This is not damaging and does not impair the appliance in its functions.
If you do not intend to use the juicer for a long time, wrap the cable around the
cable retainer on the underside of the juicer.
Possible causes
The mains plug
connected.
The appliance is not switched on. Switch the appliance on with
The clamps
The filter
You are working too fast.
The filter
until the arrow points to the opened lock
. To re-close the lid, place it on the pusher so that
. Then turn it until the arrow points at
.
is not
are not secured.
is blocked.
is blocked.
:
can be
Possible solutions
Connect the appliance to
a mains power socket.
the On/Off switch .
Close the clamps .
Switch the juicer off immediately
and pull out the mains plug
Remove the blockage (see sec-
tion "Juicing").
Work a little more slowly.
Clean the filter (see section
"Cleaning and Care").
on
.
SFE 450 C1