Storage - Silvercrest SFEE 800 A1 Bedienungsanleitung

Clean the pusher 1, the juice container 5, the separate juice collector t,
■
the foam separator z, the housing lid 3 and the container for fruit and
vegetable pulp q in warm soapy water and rinse them carefully.
NOTE
►
► If possible, use the upper basket of the dishwasher and make sure the
components are not jammed in.
To clean the filters w, use the supplied cleaning brush r:
Turn the lid of the pusher 1 until the arrow points to the opened lock
■
the pusher shaft. You can now remove the lid. The cleaning brush r can be
found inside the pusher 1. To re-close the lid, place it on the pusher so that
the arrow points to the opened lock
the closed lock
Hold the filter w (with the underside upwards) under running water and
■
clean it with the cleaning brush r.
NOTE
►
► If possible, use the upper basket of the dishwasher and make sure that the
filter w is not jammed in.
Colouring:
■ Some fruits or vegetables can permanently discolour parts of the juicer.
This is not damaging and does not impair the appliance in its functions.

Storage

If you do not intend to use the juicer for a long time, wrap the cable around the
cable retainer 0 on the underside of the juicer.
■ 56 │ GB │ MT
The pusher 1, the juice container 5, the housing lid 3, the separate
juice collector t, the foam separator z and the container for fruit
and vegetable pulp q are dishwasher safe and can be cleaned in the
dishwasher.
. The lid now sits firmly in place.
The filter w is dishwasher-safe and can be cleaned in the dishwasher.
Nevertheless, remove any fruit residues from the filter w using the
cleaning brush r beforehand. Otherwise, the fine-mesh sieve of the
filter w will not get clean.
. Then turn it until the arrow points at
on
SFEE 800 A1