Invacare ScanBed 755 Bedienungsanleitung Seite 15

Mounting the bed ends
Lift the bed end and place on the fittings at both sides. Push down to click into place. The
locking pin must then be rotated and locked into postion.
NB! It is recommended that the Line side rail is used in combination with Susanne, Maria,
Sophie, Victoria and Emma bed ends. The steel side rails are optional (but are designed
to be used with Oda and Piggy bed ends).
Dismounting of bed ends
Pull the locking pin out, and turn halfway
to lock the pin.
Repeat on the other side.
Pull the bed end up and out.
Mounting/dismounting
the steel side rail
Mounting: Refer to the labelling on
the side rail. Tighten the side rail with
2 finger screws.
Dismounting: Loosen the finger
screws, and remove the steel side rail.
UM_1518190_GB_DK_SE_NO_FI_DE_NL_FR_IT_PT_ver06.indd 18
To avoid injury, it is essential the locking pins are engaged, to avoid the bed
ends from falling off.
If the bed is used by restless (spasms) or confused persons, the Victoria bed
end (with removale plate) must not be installed!
When using steel side rails / support handles, it is essential for security
reasons, that the distance from bed end to the upper edge of the side rail /
support handle is either less than 6 cm or more than 25 cm.
18
3-6 cm
3-6 cm
2011-11-08 15:24:00