Operating The Built-In Mattress Support Extension - Invacare Scanbed 755 Bedienungsanleitung

Parts of a standard bed
1. Allen key
2. Backrest
3. Seat section
4. Leg section motor
5. Thigh section
6. Thigh section motor
7. Leg section
8. Top frame, foot end
9. Brake pedal for beds
provided with central
brake

Operating the built-in mattress support extension

TM
The SB755 can be extended respectively 5 and 10 cm in both head- and foot end, 20 cm
in total. To be able to extend the bed, the hexagonal key must be used.
The key is located on the inner side of the cross bar in the head end.
To extend the bed in the foot end, the following must be done:
1. The side rail is removed (see section 5).
2. Remove the two screws that holds the bed end bracket in the bed foot end by the use of
the hexagonal key.
3. Pull out the bed end brackets 5 or 10 cm, and install/tighten both screws.
4. Loosen both screws that holds the mattress support extension, pull out the extension to
desired position, and tighten both screws.
5. Replace the mattress or put in the mattress extension.
6. Install the side rail(s).
UM_1518190_GB_DK_SE_NO_FI_DE_NL_FR_IT_PT_ver06.indd 14
4
5
8
7
10. Brake for beds provided
with brake castors
11. Base frame
12. Backrest motor
13. Shear arms
14. Top frame, head end
15. Control unit
16. Mattress retainer
17. Mattress support
extension
1
2
3
12
6
13
9
Accessories
14
17
16
14
15
10
11
Bed ends
Bed end fittings
Support handles
Side rails
Lifting pole
Bumper wheels
ACP box
Limitation crossbar
for leg end
Backup battery
2011-11-08 15:23:52