Test Symbols; Appliance Description; Settings; Reducing The Temperature - AEG MTD 350 Anleitung

Operation - for users and contractors

2.3 Test symbols

See type plate on the appliance.
Country-specific approvals and certifications:
Germany
In line with [German] State Building Regulations, a
general test certificate has been issued for these ap-
pliances, as verification of their suitability regarding
noise emissions.
AEG
HOL
DIN 4109
P-IX 7510-I
28

3. Appliance description

The hydraulically controlled small instantaneous water
heater heats the water directly at the draw-off point.
The heating system starts automatically when the tap is
opened. The short pipe runs ensure that energy and water
losses are minimall.
The DHW output depends on the cold water temperature,
the heating output and the flow rate.
The bare wire heating system is suitable for hard and soft
water areas. This heating system has a low susceptibility
to scale build-up. The heating system ensures quick and
efficient DHW provision at the hand washbasin.
Fitting the special aerator supplied provides an optimum
water jet.

4. Settings

The appliance heating system switches on automatically
as soon as you open the DHW valve at the tap or activate
the sensor of a sensor tap. The water is heated. The water
temperature can be adjusted at the tap:
For the start volume, see chapter "Specification / Data
table / On".
Increasing the temperature
» Reduce the flow rate at the tap.

Reducing the temperature

» Open the tap further or add more cold water.
Following an interruption of the water supply
See chapter "Commissioning / Recommissioning".