Appliance description
1
Lid
2
Heat insulated handles
3
Pouring lever
4
Pouring tap
5
Signal tone switch
6
Temperature regulator
7
Control lamp
8
Preserving grill
9
Cable retainer
Commissioning
Installation of the appliance
•
Completely unwind the power cable from the
cable retainer
9
.
•
Place the appliance on a level and slip-free surface.
Ensure that a wall power socket is easily acces-
sible.
Preparing the appliance for use
•
Clean the appliance as described in the chapter
"Cleaning and Care"..
•
Insert the power plug into a power socket.
Attention :
NEVER operate the appliance in a no-load
condition!
Doing so could irreparably damage the appliance!
•
Fill the appliance with ca. 5 liters of water and
bring it to the boil (see chapter "Switching the
appliance on and off").
Attention :
When it is hot, take hold of the appliance ONLY
by means of the heat insulated handles
Burns!
Note:
On the first use the generation of a slight smell can
occur, due to residues from the production. It is com-
pletely harmless and disperses after a short time.
Provide for sufficient ventilation, for example, open
a window.
Switching the appliance on and off
•
Adjust the temperature regulator
sired heating level. The control lamp
When the selected temperature has been rea-
ched, the control lamp
lamp glows again during operation when the
temperature falls below the selected level and
the preserving boiler needs to reheat itself.
•
Should you wish to hear a signal tone when
the selected temperature has been reached,
place the signal tone switch
have selected the temperature. A signal tone
sounds when the selected temperature has
been reached.
•
When you wish to switch the appliance off,
turn the temperature controller
tion OFF.
•
When the appliance is not in use, always re-
move the plug from the mains power socket.
2
. Risk of
- 33 -
6
to the de-
7
glows.
7
goes out. The control
5
at "I" after you
6
to the posi-