Herunterladen Inhalt Inhalt Diese Seite drucken

Hydraulic Lift; Controlled Draft Lift - GOLDONI 900 RSDT series Bedienung Und Instandhaltung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 80
Synchronised PTO
This PTO is synchronised with all the gears and is used with trailers with drive
wheels.
The PTO is engaged as follows:
Lever n.3 fig.1 in synchronised position (n.2 fig.7)
Lever n.6 fig.1 in position F fig.8
Ratio between wheel revolution and PTO: 1/15.13

4.8 HYDRAULIC LIFT

This is a rear 3-point hitch.
It is operated with lever n.1 fig.1 and pulling up the ring under the knob to release
the lever from its home position.
Lever forward = Attachment lifted
Lever down = Attachment lowered (floating operation for jobs where the land
contour has to be followed).
Lever at intermediate positions: holds the implement at various heights.
Floating
Floating mode frees the links completely and permits the implement mounted to
follow the contour of the ground (for example: cultivating).
A trailer can be lifted using the independent single acting hydraulic take-off (n.36
fig.3).
This hydraulic take-off is controlled by the lift control lever, (n.1 fig.1) and works
when the lift cylinders reach full stroke.

4.8.1 Controlled draft lift

Tractors equipped with draft control can be used in the following jobs:
Controlled position
Ideal for jobs that require constant position of the attachment (drills,
dozer/grader, trailed manure spreaders, mower bars, etc.).
Insert the wedge n.1 fig.21 to lock the lever; move lever n.1 fig.22 all the way
back; move lever n.2 forward to lower the attachment or back to raise it.
The attachment can be locked at the desired height with knob n.3 fig.22.
Draft control,
Designed to adjust lift strain and to lessen tractor slipping (plough, harrow, rotary
cultivator, etc.).
Remove the locking wedge n.1 fig.21; shift lever n.2 fig.22 all the way back.
Lower of raise the implement with lever n.1 fig.22.
Mixed mode (or modulated draft),
This is a combination of the previous two operating modes and ideal for working
under draft control conditions but on ground with differing consistency.
• Bury the implement using lever n.2 fig.22 to the required depth- Use lever n.1
52

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

933 rsdt938 rsdt945 rsdt

Inhaltsverzeichnis