Long-Term Storage; Transportation; Troubleshooting - WACKER BS65Y Betriebsanleitung/Ersatzteilliste

1A OPERATION

1.21 Long-term Storage

1. Drain fuel from tank.
2. Start engine and run until remaining fuel is used.
3. Remove spark plug. Pour approximately 1 oz. (30 ml) of clean SAE 30W engine oil into cylinder through spark plug
opening.
4. Pull starter rope slowly to distribute oil in engine.
5. Re-install spark plug.

1.22 Transportation

1. Always shut off engine and close fuel valve
when transporting machine.
2. Make sure lifting device has enough capacity
to hold machine (see identification plate on
machine for weight).
3. Use central lifting point
chine.
4. Tie down machine on vehicle to prevent it
from tipping, falling, or rolling. Lay machine
down flat and tie to vehicle at points
(c)
.
CAUTION:
Drain fuel tank as required to
prevent fuel leaking from cap (d).

1.23 Troubleshooting

Problem / Symptom
Engine does not start, or stalls.
Engine does not accelerate,
is hard to start, or runs erratically.
Engine overheats.
Engine runs; rammer does not tamp.
Engine runs, rammer operation is erratic.
1A-12
(a)
when lifting ma-
(b)
and
Reason / Remedy
1. No fuel in tank.
2. Spark plug fouled.
3. Fuel valve closed.
1. Improper fuel mix. Too much oil.
2. Spark plug fouled.
3. Clean muffler and exhaust port.
4. Crankshaft seals are leaking.
5. Air cleaner may be clogged.
1. Improper fuel mix. Not enough oil.
2. Carburetor set too lean.
3. Clean cooling fins and fan blades.
1. Inspect clutch for damage. Replace if necessary.
2. Broken connecting rod or crankgear.
3. Low engine performance. Compression loss.
1. Oil/grease on clutch.
2. Broken/worn springs.
3. Soil buildup on ramming shoe.
4. Broken parts in ramming system or crankcase.
5. Engine operating speed is too high.
a
d
b
Plugged exhaust port.
BS65Y
1014SD90
c