Lubrication; Shoe Hardware; Carburetor Adjustments - WACKER BS65Y Betriebsanleitung/Ersatzteilliste

BS65Y

1.18 Lubrication

1. Change ramming system oil after first 50 hours of
operation and every 300 hours thereafter. To drain oil,
(d)
remove plug and tilt machine back until it is resting
on handle.
2. With rammer on level surface, add oil through plug
Proper ramming system lubrication is indicated when
approximately 1/2–3/4 of the sightglass

1.19 Shoe Hardware

On new machines, or after replacing shoe, check and
(g, h)
tighten shoe hardware
operation. Inspect hardware every week thereafter.
Torque hardware as specified.

1.20 Carburetor Adjustments

Bing Carburetor
Idle Speed
Adjust engine idle speed with the throttle closed and the
engine running at idle. Attach tachometer and set idle
(i)
speed screw on carburetor to achieve the specified
idle speed. Refer to "Technical Data".
No other carburetor adjustments are required.
(e)
.
(f)
is full.
after the first 5 hours of
OPERATION
e
58 ft.lbs.
(79 Nm)
g
i
1A
f
d
1014SD95
18 ft.lbs.
(25 Nm)
h
1004SD06
1002SD11
1A-11