Use; Manually Adjustable Sections; Breakdowns - Auping K2 Gebrauchsanweisung

4. Use

4.1 Manually adjustable sections

Foot end
The foot end has six adjustable
positions. Carefully pull on the handle
until the desired position is reached. To
put the foot end into a lower position
you must first pull it up as far as it will
go and then lower it again.
Back section
The back section has 13 adjustable
pos itions. Carefully pull on the handle
until the desired position is reached.
To put the back section into a lower
position you must first pull it up as far
as it will go.
Undesirable noises
(bed squeaks and creaks)
Undesirable noises
(bed squeaks and creaks)
Undesirable noises
(bed squeaks and creaks)
Undesirable noises
(bed squeaks and creaks)
Undesirable noises
(bed squeaks and creaks)
_0EJ0K_6073 BW.pdf - pag.11

5. Breakdowns

While an electrical fault may be a
nuisance, it is never dangerous. All
motors and controls are fitted with all
necessary safety devices and have
double insulation.
The
solutions to malfunctions. If you have
any doubts contact your dealer.
Cause
Caused by moving parts touching
each other.
The box spring is not leveled
because the floor is not absolutely
flat.
The reason for this may be a missing
part, or parts that have not been
tightened properly or have become
loose when the bed was moved.
The bed is not positioned away from
the wall.
There are unwanted objects in the
bed that should not be there
(spoons, forks, pens, etc.).
LET OP !!! Lage resolutie!
table below gives
Solution
Apply Teflon spray. Do not use oil.
Make sure the floor is absolutely
leveled.
Tighten parts.
Position the bed away from the wall.
Remove those objects.
EN
possible
5
April 4, 2012