Preparing For Use; Tips For Use; Use; Electrically Adjustable Sections - Auping K2 type 88 Gebrauchsanweisung

3.7 Preparing for use

Check that the mesh base can move
freely. Only adjust the mesh base while
it is in a horizontal position, securely
fixed to the supporting legs, or to the
supports provided within the bed
surround.Check that the mattress is
attached to the mesh base properly.
Check that the mattress is attached to
the mesh base properly. Insert the plug
into the wall socket. The plug has a
safety cut-out.
Attention
The cable clips can be used to prevent
an untidy tangle of leads under the bed.
Attach these clips to the underside of
the stationary part of the frame. Make
sure that the cables never become
jammed between the moving parts.
Place the cable clips at least 25 mm
from the moving parts.

3.8 Tips for use

A new mattress has a certain amount of
rigidity, which will disappear within a
few days. Consequently, your mattress
will not optimally follow the contours of
the mesh base when it is initially
adjusted. We therefore recommend
that you lie down on the mattress while
adjusting the positions for the first time.

4. Use

4.1 Electrically adjustable sections

The handset is used to adjust the elec-
trically adjustable sections (see fig. 7).
1. Raise head support
2. Lower head support
3. Raise back section
4. Lower back section
5. Raise foot end
6. Lower foot end
7. Raise head support, back section
and foot end
8. Lower head support, back section
and foot end
Press one of the 'up' or 'down'
buttons, holding it down until the
desired position is reached. Only one
button can be operated at a time.
fig. 7
GB7