Inhaltsverzeichnis
Werbung
2
INSTALL
MOWER
AND DRIVE
BELT
Be sure tractor is on level surface and mower suspension
arms (3) are raised with attachment lift control. Engage
perking brake,
•
Cut and remove ties secudncj anti-sway bar (1) and belts.
Swing anti-sway bar to left side of mower deck.
•
Slide mower under tractor.
IMPORTANT:
CHECK BELT FOR PROPER ROUTING IN ALL
MOWER PULLEY GROOVES.
•
Turn height adjustment knob counterclockwise
until it
stops.
Lower mower suspension arms (3) with attachment lift
control.
•
Be sure bait tension rod (2) is in disengaged position.
•
Install belt into electdc ciutch pulley groove (8).
•
Place the suspension arms (3) on outward pointing deck
pins. Retain with double loop retainer springs (B).
•
Install front plate assembly (4) to tractor suspension
brackets (5) and retain with single loop retainer springs
(A) as shown.
•
Position front plate assembly between front mower brack-
ets 46). Raise deck and plate assembly to align holes
and insert flanged pins (7). Secure pins with double loop
retainer springs (B) between the plate assembly and
mower brackets.
NOTE: To assist in locating hole in flanged pin (7), the hole
in pin is inline with notch on head of pin.
•
Engage belt tension rod by pushing rod (2) into locking
bracket (9).
•
Connect anti-sway bar (1) to chassis bracket (1 O) under
left footrest and retain with double loop retainer spring
(B).
•
Turn height adjustment knob clockwise to remove slack
fm rom mower suspension.
•
Raise deck to highest position.
•
Adjust gauge whseis (11) before operating mower.
1. Anti-sway bar
2.
Belt tension rod
3.
Suspension arms
4.
Front plate assembly
5.
Tractor suspension bracket
6.
Front mower bracket
7.
Ranged pin
8.
Clutch pulley
9.
Locking Bracket
10. Chassis bracket
11. Gauge wheel
3
9
A. Single loopretainerspring
B. Doubleloopretainerspring
11
2
6
8
.,p
23
Werbung
Inhaltsverzeichnis
