Memory/Preset Operation; Preset Button - Toshiba RAS-M10GDCV-E Betriebsanleitung

MEMORY/PRESET OPERATION

Memorize the frequently used operation setting by the MEMO button for convenience.
Start the air conditioner in the operation mode which you want the remote controller to memorize.
Push the button as follows while the air conditioner is in operation.
a MEMO button
Push this button briefly to standby memorizing the setting.
All the icons currently displayed except for the clock display and
b MEMO button
Push and hold the MEMO button for more than 3 seconds while the display flashes.
The mark is indicated and the setting is memorized.
• If you do not push the MEMO button within 3 seconds or if you push another button, the
MEMORY setting is cancelled.
• Operation modes which can be memorized with the MEMO button are MODE,
Temperature, FAN, TIMER and High power.
To operate the air conditioner with the setting memorized by the MEMO button.
a PRESET button
Push the PRESET button. The setting memorized with the MEMO button will be
indicated and the air conditioner operates with regards to the setting.
• The OPERATION lamp (green) on the switch panel of the indoor unit goes on, and
operation starts after approximately 3 minutes.
• Initial setting :
MODE : AUTO
Temperature : 22
EN
mark flashes.
14