Operation Procedure - Toshiba SUPER-HRM MMY-MAP0802FT8 Installationshandbuch

7
ADDRESS SETUP
Manual address setup from remote controller
In case to decide an address of the indoor unit prior to finish of indoor electric wiring work and unpracticed outdoor
electric wiring work (Manual setup from wired remote controller)
Arrange indoor unit in which address
is set up and the wired remote controller to 1 : 1.
(Wiring example in 2 lines)
Line 1
Outdoor
Indoor
Remote
controller
®
Header
® 1
Line address 1
® 2
Indoor address 1
2
Group address 1
In the above example, under condition of no
inter-unit wire of the wired remote controller,
set the address after individual connecting of
the wired remote controller.
Group address
Individual : 0000
Header unit : 0001
}
In case of group control
Follower unit : 0002

Operation procedure

® ® ®
1 2 3 4
® ® ®
7 8 9 10
Data
2, 5, 8
4, 7, 10
11
Line 2
(Line address) → → → → →
Follower
1 2 2
3 1 2
2 2 2
(Indoor address) → → → → →
(Group address) → → → → →
® ® ®
5 6
®
11
End
SET DATA SETTING
UNIT No.
R.C. No.
TEMP.
TIMER SET FAN
TIME SWING/FIX
FILTER
RESET TEST SET CL UNIT
Turn on the power.
1
Push simultaneously
seconds or more.
LCD changes to flashing.
2
Using the setup temp.
the item code.
3
Using the timer time
address.
(Match it with the line address on the interface P.C.
board of the header unit in the identical refrigerant line.)
4
SET
Push button.
(OK when display goes on.)
5
Using the setup temp.
the item code.
6
Using the timer time
indoor address.
7
SET
Push button.
(OK when display goes on.)
8
Using the setup temp.
the item code.
9
Using the timer time
0000
, Header unit =
.
10
SET
Push button.
(OK when display goes on.)
11
TEST
Push button.
Setup operation finished.
(Status returns to normal stop status.)
CODE No.
Item code
ON / OFF
3, 6, 9
MODE
VENT
1
11
SET CL TEST
+ + buttons for 4
/ buttons, set
/ buttons, set up the line
/ buttons, set
/ buttons, set up the
/ buttons, set
/ buttons, set Individual =
0001
, Follower unit =
12
to
13
to
14
to
0002