Use As A Grass Trimmer; Use As A Hedge Trimmer; Changing The Blades; Maintenance And Cleaning - FLORABEST FGS 10 A1 Originalbetriebsanleitung

Use as a grass trimmer

Assembling/Removing the Wheels:
• To mount the wheels (5), as-
semble the lateral axle (23) into
the both guidance elements (24)
at the underside of the tool and
push it down. You will hear the
axle click into place in the cor-
responding notches on the left
and right-hand side of the tool.
•
index finger and thumb (clothes
peg grip) and remove the
wheels.
• Swinging the Equipment: Push the
catch (
6) on the right-hand side of
the blades. You can now tilt the blade
up and down.
• Push the tool over the ground using
the wheels (
that you keep an even cutting height.
The telescopic shaft (
make work easier.
• Grass is best cut when dry and not
too long.

Use as a hedge trimmer

• Move the unit forward evenly.
• The double-sided cutting heads en-
able cutting in both directions or by
swinging the unit from side to side.

Changing the blades

Remove the battery (7) from the
unit before changing the blades
(11/12).
To remove the
wheels (5) ,
push the wheels
apart using your
5). This will ensure
20) will
1. Press the two quick-release
catches (25) on the battery (7)
and pull the battery out of the unit.
2. Push the safety switch (26) on
the underside of the unit to „UN-
LOCK" and lift the blade cover
(27) off.
3. Remove the whole blade unit
(11/12).
4. Position the blade onto the unit.
Make sure the fixed blade plate
(28) points outwards. The re-
cesses on the blade fit onto the
pins in the equipment casing.
Note: If the blade drive (29) has
turned around, turn it by hand
until you can position the blades
(11/12).
5. Place the blade cover (27) onto
the unit and move the safety
catch (26) to „LOCK".
6. Place the battery (7) into the unit
again.

Maintenance and Cleaning

Leave any work not covered in
this manual to our Service Cen-
tre. Only use original parts.
Remove the battery (
the unit before servicing it.
Wear gloves when handling the
blades (
Clean and service the unit regularly as fol-
lows. This guarantees a long life for your
unit:
• Check the covers and guards for dam-
age and correct position. If necessary,
7) from
11/12)).
GB
13