Playing The Kit; Switching The Power On And Off; Selecting A Kit - Roland HD-3 V-Drums Lite Bedienungsanleitung

Playing the Kit

Switching the Power On and Off

For details on connecting the HD-3 sound
module, refer to the separate "Setup Guide. "
* Once the connections have been
completed, turn on power to your
various devices in the order specified.
By turning on devices in the wrong order,
you risk causing malfunction and/or
damage to speakers and other devices.
1.
Make sure that the HD-3's [VOLUME]
knob, and that of any connected drum
monitor, is set to the minimum level .
2.
Hold down the [POWER] switch of
the HD-3 sound module to turn on
the unit . To turn off the unit, hold
down the [POWER] switch for several
seconds .
* Before switching the power on/off,
always be sure to turn the volume
down. Even with the volume turned
down, you might hear some sound
when switching the power on/off.
However, this is normal and does not
indicate a malfunction.
3.
Turn on the power of the connected
drum monitor .
4.
Raise the volume of both to get the
sound level required .
* This unit is equipped with a protection
circuit. A brief interval (a few seconds)
after power up is required before the
unit will operate normally.
* Turn the power off by reversing the
order in which you turned the power on.

Selecting a Kit

A drum kit consists of sounds assigned to
each pad. In some cases, the sound will
change depending upon your playing
dynamics.
1.
Press one of the kit buttons ([1]–[10]) .
Pressing these buttons will call up different
kits.
2.
Press the [VARIATION] button .
Variation kits are provided for each kit.
Pressing the [VARIATION] button will switch
to the variation kit of the selected drum kit.
The [VARIATION] button will light if a
variation kit is selected.
11