Assembly Iris Led 10 W; Load Data; Assembly Arm System - Derungs D med IRIS LED 10 Montage- Und Gebrauchsanweisung


Connect luminaire to mains

Push cover and end ring over the ceiling bracket
and tighten them (0.5Nm)

Continue with luminaire head assembly, see
Chapter 7
5

ASSEMBLY IRIS LED 10 W

5.1

Load data

Bending moment M
B
Vertical weight F
G
5.2

Assembly arm system

DANGER
Assembly by qualified personnel

Assembly must be carried out by qualified
personnel only. Lack of appropriate knowledge
could be life-threatening.
DANGER
Life-threatening danger from falling luminaire

The ceiling must be made of solid concrete to
guarantee a secure hold.
Electric shocks are life threatening

Electric shocks are life-threatening

CAUTION
Take account of the wall bracket position


160Nm
108N



DANGER
It must be possible to separate the light from
the mains by an external all-pole switch
(not included).
DANGER
Voltage supply from the power connection
must be protected on all poles by means of an
overcurrent release (according to national
installation requirements; it is not included in
the scope of supply).
The wall bracket must be aligned vertically, as
shown in the image.
Failure to comply with correct alignment will
compromise mechanical safety.
Make minimum 4 opposited drill hole markings
(Ø13mm), note the position of the Ø60mm drill
hole for electrical connections
Check clearances
Drill the bore holes, then blow them out using
bellows
ENG
31