Derungs D med IRIS LED 10 Montage- Und Gebrauchsanweisung Seite 27

Perform this assembly step on a flat

surface:
Lay arm 1 down flat

Pull cable (from arm) through ceiling conduit 2

Insert slide pad 3 into the groove at the top

Push ceiling conduit 2 (with boring 4 aligned

upward ) and arm 1 together
Secure slide pad 3 by screwing in the threaded

pin 5 (up to the stop)
Release threaded pin 5 by a ¼ turn maximum

and check function

Also check:
Threaded pin must now be flush
WARNING
Risk of injury from falling parts

Assembly must be performed by two people.
WARNING
Risk of injury from falling luminaire

The ceiling must be made of solid concrete to
guarantee a secure hold.

Use suitable wall anchors.

Hold the ceiling bracket against the ceiling and
strike the ceiling anchor with a hammer

Tighten fastening in line with manufacturer's
data

Place cover and end ring on the ceiling tube

Pull the light cable of the ceiling tube through
the light mount.

Insert ceiling tube into light mount
Secure using the M8 safety screw and nut 1

Tighten M8 safety screw and nut 1 (20 Nm /

14.75 lbf ft)
Tighten all 4 threaded pins 2 (5 Nm / 3.68 lbf ft)

DANGER
Mortal danger from electric shock

Disconnect from the power supply and secure
against unintended switching on before starting
work on the power connection.

Make power connection
ENG
27