Derungs D med IRIS LED 10 Montage- Und Gebrauchsanweisung Seite 32

ENG

Hold the wall bearing onto the wall and strike
the wall anchor with a hammer

Tighten fastening in line with manufacturer
data
WARNING
The light will fall
incorrectly

The threaded pin must be screwed in fully and
correctly.
Perform this assembly step on a flat

surface:
Lay arm 1 down flat

Pull cable (from the arm) through wall angle 2

Insert slide pad 3 into the groove at the top

Push wall angle 2 (with boring 4 aligned

upward) and arm 1 together
Secure slide pad 2 by screwing in the threaded

pin 5 (up to the stop)
Release threaded pin 5 by a ¼ turn maximum

and check function

Also check:
Threaded pin must now be flush

Remove fastening screw.
32
if fastening is done
Insert wall angle 1 (with closure ring 2 and

hood 3 in position) into the wall bracket 4 and
simultaneously pull the cable through the
rectangular cutout

Wall angle in vertical alignment, mount with M8
self-locking bolt and nut and tighten 1 (20 Nm)
Tighten all 4 threaded pins 2 (5 Nm)

DANGER
Mortal danger from electric shock

Disconnect from the power supply and secure
against unintended switching on before starting
work on the power connection.

Make power connection

Connect luminaire to mains