Sterilisable Hand Grip; Safety Inspections; 10.1 Setting The Spring Force - Derungs D med IRIS LED 10 Montage- Und Gebrauchsanweisung

9.1

Sterilisable hand grip


Sterilization must be carried out in accordance
with ISO 17665-1 (Sterilization of health care
products - Moist heat).
CAUTION
Damage to the hand grip

Do not sterilize with hot air

Package the hand grip in a sterile pouch before
sterilization.

The hand grip is designed exclusively for damp
sterilization with 3 times fractioned pre-vacuum
and saturated steam
parameters:
Temperature
Overpressure
Dwell time
Vacuum drying
WARNING
Warning against burns

The hand grip must be cooled to room
temperature before use.

After sterilization
mechanical integrity.

Do not use damages hand grips.
10

SAFETY INSPECTIONS

DANGER
Electric shocks are life threatening

Remove the connector from the power supply
and put the switch in the "OFF" position.

The connector cable must be checked for
damage at least once per year.
CAUTION

Maintenance and repairs must only be carried
out by qualified electricians.

The corresponding user profile is described in
Chapter 1, Safety instructions.
with the following
134°C
2.0 bar
6 min
20 min
check the hand grip

10.1 Setting the spring force

DANGER
Injury hazard

The spring force must be set by qualified
professionals only

The spring arm is under a high spring load. If
the luminaire head terminal is not moved to the
upper cantilever arm position, the cantilever
arm will spring up, possibly causing serious
injury. Only remove the luminaire head
terminal if the cantilever arm is in the upper
position.
CAUTION
The spring force is set at the optimum setting as
supplied from the factory

Loosen 4x countersunk screw M3 and remove
cover
for
Setting spring force with punch (4mm):
+ increase

or
- reduce

until you reach the desired spring force

Mount cover and secure with M2 countersunk
screw
ENG
35